The ENGINEER PAD-11 is a precision crimping tool fitted with small-size crimping die plates - these die plates can be easily swapped for other sizes allowing an easy upgrade path.
For example - you might initially only have a need to crimp small-size pins, but then at a later date you're faced with crimping larger pins - in this scenario, you'd just need to purchase the larger die plate set - the PAD-12S or the PAD-13S.
If you opt to purchase the other two die plate sets available (the PAD-12S & PAD-13S), you'll then have the capability to crimp a very broad range of pin types & sizes - but without having to own & carry numerous crimping tools (which would be costly and add clutter and extra weight to your tool case).
For example - you might initially only have a need to crimp small-size pins, but then at a later date you're faced with crimping larger pins - in this scenario, you'd just need to purchase the larger die plate set - the PAD-12S or the PAD-13S.
If you opt to purchase the other two die plate sets available (the PAD-12S & PAD-13S), you'll then have the capability to crimp a very broad range of pin types & sizes - but without having to own & carry numerous crimping tools (which would be costly and add clutter and extra weight to your tool case).
- ultra precise crimping tool (with inter-changeable die plates) for open-barrel contacts / pins
- easy die plate swap-out, with perfect alignment into the frame's jaws
- supplied pre-fitted with a 'Small' die plate set (other die plate sizes available)
- allows crimping of over 100 different manufacturer pin types
- die widths - 0.7mm, 1.0mm, 1.3mm, 1.6mm, 1.9mm & 2.2mm
- integral wire stripper & cutter
- spring loaded handles for easy operation (handles latch shut for storage)
- oil-resistant TPR (thermoplastic rubber) grips for unmatched comfort (strap holes at end of handles)
- 2.5mm hex key wrench included as a standard accessory
- constructed from special alloy steel
- made in Japan (ROHS compliant)
