NZ-12 component cutters (flush cutting)
£13.33
- • super fine jaw cutting edge allows totally flush cutting
- • each tip measures just 0.3mm - perfect for cutting narrow pitch QFP & SOP components
- • parallel grip design allows you to hold horizontally to the PCB (no need to raise your elbow up uncomfortably)
- • cutting action designed to avoid tearing off or damaging the circuit board solder joint
- • ergonomical cushioned elastomer handle for comfortable use
- • spring loaded grips for easy operation
- • lightweight (just 45g)
- • cutting capacity: 0.6mm copper wire
- • material: S58C Carbon Steel
- • made in Japan (ROHS compliant)
The ENGINEER NZ-12 are flush cutting 'offset' cutters.
The jaws have a super fine cutting edge, which enables easy flush cutting of electronic component leads and avoids tearing or solder cracking on the circuit board.
The jaws have a super fine cutting edge, which enables easy flush cutting of electronic component leads and avoids tearing or solder cracking on the circuit board.
NZ-12
56 Items
- • super fine jaw cutting edge allows totally flush cutting
- • each tip measures just 0.3mm - perfect for cutting narrow pitch QFP & SOP components
- • parallel grip design allows you to hold horizontally to the PCB (no need to raise your elbow up uncomfortably)
- • cutting action designed to avoid tearing off or damaging the circuit board solder joint
- • ergonomical cushioned elastomer handle for comfortable use
- • spring loaded grips for easy operation
- • lightweight (just 45g)
- • cutting capacity: 0.6mm copper wire
- • material: S58C Carbon Steel
- • made in Japan (ROHS compliant)